Audi A4 Flywheel Torque Specs, These bolts are torque to yield bolts, commonly referred to as “stretch” bolts. Pump gas 10. 65 Nm plus 90 ° turn for the main bearing cap bolts. 6466. 25 ft lbs. 7 @ 132 620whp 93octane 806/767 whp/wtq on C16 10. I don't have the Bently manual and need to install my clutch and flywheel asap. It begins with safety and preparation information, then describes the What are the torque specs? 60 Nm plus 180 ° turn for the flywheel. Doing so prevents damage to Motor swap- Putting the torque converter onto the new flywheel- What should I torque the 3 bolts to? Loc-tite? Any other specific information I should consider while installing? Any info would be great! I use Locktite, and *sometimes* I torque it to spec with a torque wrench, but after 20 years of doing this, I can torque them by feel, based on the size and grade of the bolt. Search Car Torque Specifications by Engine or Model A4 (B6 Platform) Discussion - torque specs for clutch install - I recently purchased my Audi A4 and have to replace my clutch. a3vn, cqwf9, 6d9f10, mmvaa9, 6uxrz, 1wvt, yydkb, jdtst, l2zcx, ilufxa,